Bongkar Mod Smok Alien / Disassemble Smok Alien / Ohm Too High – Ohm Too Low

Bongkar Mod Smok Alien / Disassemble Smok Alien / Ohm Too High – Ohm Too Low

Liquid leaks into the Alien Smok circuit, if without RDA when firing mod displays OHM TOO HIGH, and when installed RDA displays OHM TOO LOW, this time the solution is only unloaded and cleaned with tissue, hand blower and dried with solder Steam.

PS: This method doesn’t always work because “Ohm Too Low” is a common problem for Alien Smok and many try other methods and succeed. If you experience it, then you can try:

1. Install the RDA by turning the RDA slowly until the coil is read, If the coil is read, tighten it (don’t install the RDA too tight).
2. If the Coil has been read but is not accurate, try setting Ohm via the Menu (by pressing the Firing button 3 times quickly, then setting the Ohm value closest)
3. If it doesn’t work, try repeating from step 1, if it works but Ohm is unstable / alternating in value, it is likely that the chip in the circuit is damaged.
4. If the Ohm reading mode is always low / does not match / half of the actual ohm value … then to be able to vape, you have to use RDA single coil.

5. If your case is Off / when you installed the battery but the mod cannot be turned on when pressed 5x, then it is possible that the middle cable/Battery balance cable is sold off.

Liquid bocor dan masuk ke rangkaian Alien Smok, jika tanpa RDA saat di Firing mod menampilkan OHM TOO HIGH, dan saat di pasang RDA menampilkan OHM TOO LOW, solusi kali ini Mod hanya di bongkar lalu dibersihkan dengan tisu, hand blower dan di keringkan dengan Solder Uap.

NB: Cara ini tidak selalu berhasil karena “Ohm Too Low” adalah penyakit umum Alien Smok dan banyak yang mencoba cara lain dan berhasil. Jika anda mengalaminya maka bisa anda coba :

1.Pasang RDA dengan memutar RDA pelan-pelan sampai coil terbaca, Jika koil terbaca,baru kencangkan.(jangan memasang RDA terlalu kencang).
2.Jika Coil sudah terbaca namun tidak akurat, coba seting Ohm lewat Menu (dengan menekan tombol Firing 3 kali dengan cepat, lalu seting nilai Ohm yang paling mendekati)
3.Jika tidak berhasil, coba ulangi dari langkah 1, jika berhasil namun Ohm tidak stabil/ berganti-ganti nilai maka kemungkinan chip di rangkaiannya rusak.
4.Jika Mod membaca Ohm selalu rendah/tidak sesuai/setengah dari nilai ohm sebenarnya..maka untuk bisa nge-vape, terpaksa anda harus pakai RDA single coil.

5. Jika kasus anda Mod Mati / Saat pertama di pasang batere tampil namun mod tidak bisa di hidupkan saat di tekan 5x, maka kemungkinan kabel tengah batere putus/ solderan lepas.

Semoga Bermanfaat.. Sallam.

My Blog : m

[optin-cat id=7010]